Most Common Cisco ASA Interview Questions

Question 1 What is the Firewall ?

Question 2 What is stateful firewall ?

Question 3 What is the ASA ?

Question 4 What is stateless firewall ?

Question 5 How many types of fail-over in ASA ?

Question 6 What Is Security Level ?

Question 7 How is gateway different from Firewall ?

Question 8 Firewalls works at which Layers ?

Question 9 How many types of ACls are used in ASA ?

Question 10 AAA stands on ?

Question 11 What are the alternatives of AAA ?

Question 12 What is Default TCP Session Timeout on ASA ?

Question 13 Why ASA does not maintain the HTTP sessions in connection table ?

Question 14 What are the steps to configure the stateful failover ?

Question 15 How can clear release the natted IPs ?

Question 16 What is the use of failover link ?

Question 17 What is the use of stateful link ?

Question 18 What is the virtual mac address and why is it required in active standby failover ?

Question 19 What type of information transfer over the stateful lnik ?

Question 20 What type of information transfer over the failover link ?

Question 21 What will be happen if only failover link failed ?

Question 22 What will be happen if only stateful link failed ?

Question 23 If you are connecting active and standby ASA through a layer 2 switch. what will be the points which need to keep in mind ?

Question 24 How can we force a ASA to take over the Active role ?

Question 25 How can force a ASA to be move into standby ?

Question 26 If failover was not auto triggered then how can trigger it ?

Question 27 How can check that stateful information for connections is updating on standby ?

Question 28 What is the clustering ?

Question 29 What is the owner and director in ASA clustering ?

Question 30 Will maintain the session information by all cluster members If a connection is established ?

Question 31 If you not entered any security level for inside interface then what will be the default security level for this interface ?

Question 32 If you not entered any security level for outside interface then what will be the default security level for this interface ?

Question 33 Can be establish the communication between two interfaces If both are configured with same security level ?

Question 34 What is a transparent firewall ?

Question 35 What is stateful inspection?

Question 36 How can we permit the communication between two interfaces with same security level ?

Question 37 How can we allow the traffic from outside to inside ?

Question 38 how can be check the NAT table ?

Question 39 how can we change mode from single to multiple ?

Question 40 How can we enable the ICMP inspection ?

Question 41 How to configure static route on ASA?

Question 42 How can we convert ASA mode into transparent mode ?

Question 43 Can we access multiple services like multiple websites using same public IP ?

Question 44 What is the DMZ Zone ?

Question 45 Clustering Up To 8 Firewall Would Be Active/active Or Active/standby?

Question 46 Can supported different hardware (ASA models) in clustering ?

Question 47 What is the use of ether type ACL ?

Question 48 What is pseudo standby ?

Question 49 What is the packet flow of ASA ?

Question 50 can we configure Active /Standby if flash is not same ?

Question 51 Can we choose different interfaces for Active and standby ?

Question 52 Can be enable preemption for active standby fail-over ?

Question 53 How many types of Nat used on ASA ?

Question 54 What is Policy NAT?

Question 55 What will be the order if we are using multiple types of NAT ?

Question 56 Can be any blimp in connectivity if active standby stateful fail-over occurred ?

Question 57 Will output contain ASA If we are doing trace-route to a destination ?